Storage

114 posts

Enable DDBoost on a Data Domain replica

Data Domain DD2500Last week I’ve been implementing two new Data Domain systems for a new customer who’d like to use these systems as backup targets for their existing Veeam 8 environment. Backup would be replicated to the secondary system to guarantee recoverability even if the first system or data center experiences a catastrophic failure. In this case replication will be handled by the Data Domain system itself. You’d like your backup software to be aware of the replicas on the secondary location. This in turn means Veeam should be able to read from the replica, which turned out to be a bit of a configuration challenge. Bring out the CLI!

Continue reading

Speed up Isilon DR – SmartConnect zone alias

These Isilon nodes need a firmware upgrade!Isilon scale-out NAS systems lean heavily on DNS. DNS plays a vital role in the way the clients access the files on the Isilon cluster: clients are distributed across nodes and network interfaces based on what your DNS reports back to the clients. This is all done by the SmartConnect component in the Isilon which is configurable up to a certain extent. In this post I’ll explain what SmartConnect does and will also share a tip to speed up your Isilon DR procedure.

Continue reading

VMAX Performance – Queue Depth Utilization Explained

Queue Utilization AlertRecently I’ve ran a project for a new EMC Symmetrix VMAX 10k installation. The install was a breeze and the migration of data to the system fairly straightforward. The customer saw some good performance improvements on the storage front and there is plenty of capacity in the system to cater for immediate growth. Yet when I opened the Unisphere for VMAX interface and browsed to the performance tab, my heart skipped a beat. What are those red queue depth utilization bars? We were seeing good response times, weren’t we? Were we at risk? How about scalability? Lets dig deeper and find out.

Continue reading

Storage Field Day 7 – Maxta Hyper-Convergence

maxtaMaxta was the last presenter at Storage Field Day 7 and spoke about their hyper-convergence product. Hyper-Convergence… what’s that all about again? Simplicity mostly: combine your compute and storage in one single unit and manage it in a single integrated user interface. Maxta offers their product in two form factors: the software-only MxSP package, or the MaxDeploy appliance which is hardware and software combined and preconfigured.  Maxta also adds three additional key values to hyper-convergence: Choice, Scalability and Cost. The former two usually don’t spring to mind when you hear about hyper-convergence products: the simplicity you seek comes with a trade-off. Let’s dive in!

Continue reading

Unisphere for VMAX – Alerting & Performance

Unisphere for VMAX dashboardSeveral weeks ago we performed a resiliency test on a VMAX10k that was about to be put into production. The customer wanted confirmation that the array was wired up properly and would respond correctly in case there were any issues like a power or disk failure.  This is fairly standard testing and makes sense: better to pull a power plug and see the array go down while there is no production running against it, right?

We pulled one power feed from each system bay and storage bay. Obviously: no problem for the VMAX, it dialed out, notified EMC it lost power on a couple of feeds and that’s it. Next up we yanked out a drive: I/O continued, the array dialed out to EMC that something was wrong with a drive, but… we didn’t see anything in Unisphere for VMAX!

Continue reading