Storage Networking

9 posts

Cisco NX-OS SNMP v3 configuration

Cisco logoAfter you’ve built a new storage environment you will probably want to monitor it and/or integrate the equipment in existing monitoring tools. SNMP is one of the protocols to use for this, but for some reason I always forget how to do a Cisco NX-OS SNMP v3 configuration. There’s a big difference in security between SNMP v2c and v3 and they’re configured quite differently: SNMPv2c uses community strings, SNMPv3 builds on the user accounts in the switch. This post will show you how to configure SNMP v3 in the DCNM SAN GUI and on the Cisco MDS NX-OS CLI.

Continue reading

Cisco Smart Zoning for NX-OS in the DCNM-SAN GUI

SmartZoning-BenefitCisco Smart Zoning greatly reduces the time needed to zone servers to storage on Cisco NX-OS SAN switches. Instead of creating numerous zones that contain one single initiator and one single target, you can now classify a WWN as initiator, target or both and throw them all into one single zone. The switch then figures out which devices should be allowed to talk with each other (based on the parameter you set for each WWN). Not only does this speed up the entire zoning process but it also helps keep the zoning interface uncluttered and minimize the risk for errors.  Let’s see how you can configure this in the DCNM-SAN GUI…

Continue reading

Brocade reset to factory default settings (or just brick it)

A pile of decommissioned Brocade switches. Or now: doorsteps.Last weekend we replaced six old Brocade SAN switches with brand new Cisco MDS 9148 switches. Everything went according to plan with no disruption to the rest of the infrastructure. I was however stuck with a bunch of old Brocade 4900 switches ready to be decommissioned. Performing a Brocade reset to factory default settings proved to be a bit of a challenge though…

If you ask Google how to perform a Brocade reset to factory default settings, you’ll find a lot of commands. One command removes the zoning, another command removes a different part of the config, a third command replaces some config values with the default settings. However, none of these commands reset the IP configuration, user passwords or switch name. Which is kind of awkward since that’s THE part of the switch config you wouldn’t want to become public domain…

Continue reading

Rebalance VNX storage paths without downtime

Recently I ran into an environment with a couple of VNX5700 systems that were attached to the front-end SAN switches with only two ports per storage processor. The customer was complaining: performance was OK most of the time but at some times during the day the performance was noticeably lower. Analysis revealed that the back-end was coping well with the workload (30-50% load on the disks and storage processors). The front-end ports were a bit (over)loaded and spewing QFULL errors. Time to cable in some extra ports and to rebalance the existing hosts over the new storage paths!

Analyzer Helper Front-End ports

Continue reading